GC45K keeps dying

Sit down Rider LP Gas Forklift questions and answers
Post Reply
NEEDACAT

GC45K keeps dying

Post by NEEDACAT »

Hey guys I have a an older GC45K and i think I have tried everything it has about k hours on it and its a work horse, it has a 4.3 vortec motor, I replaced the ignition cap and rotor, 2 ignition coil because the first one was arching, it runs great when it runs, its stays on and it turns off randomly, I thought it was the ignition switch and replaced that too, I think its a computer issue but im not sure any idea's would be great thanks
hiandlotech
Posts: 64
Joined: Fri Aug 26, 2016 8:38 pm

Re: GC45K keeps dying

Post by hiandlotech »

Hello and welcome to fixafokrlift.com!!

I have ran into this issue before, I am 99% sure it is the Ignition module, it sounds like a intermittent problem, There is not really a set step by step to determine this issue but replace the ignition module and that issue should go away, let me know the outcome of this issue thank you
Caterpillar Certified- Nissan Certified
Clark Technician- Jungheinrich
mexiCAN :mrgreen: :mrgreen:
Post Reply